Setting The Minute Minder - JUNO JB121D5 Benutzerinformation

If you touch
you set the DURATION, the
appliance switches to the
setting of the END function.
6. When the set time ends, an acoustic
signal sounds for two minutes.
and time setting flash in the display. The
appliance deactivates.
7. Touch a sensor field to stop the
acoustic signal.
8. Deactivate the appliance.
Setting the END
1. Activate the appliance and set an oven
function and temperature.
2. Touch again and again until the
display shows
flashes in the display.
3. Use or to set the END and
or to confirm. First you set the
minutes and then the hours.
When the set time ends, an acoustic signal
sounds for two minutes.
time setting flash in the display. The
appliance deactivates.
4. Touch a sensor field to stop the
acoustic signal.
5. Deactivate the appliance.
Setting the SET+GO
You can use the SET+GO function only
when the DURATION is set.
1. Set an oven function (or a programme)
and temperature (refer to "Setting the
oven function" and "Changing the
temperature").
2. Set the DURATION (refer to "Setting the
DURATION").
3. Touch again and again until
flashes in the display.
4. Touch to set the SET+GO function.
The display shows
indicator. This indicator shows which clock
function is activated.
or while
.
symbol and the
and with an
5. Touch a sensor field (apart from ON /
OFF) to start the SET+GO function.

Setting the MINUTE MINDER

Use the MINUTE MINDER to set a
countdown (maximum 23 h 59 min). This
function has no effect on the operation of
the oven. You can set the MINUTE MINDER
at any time and also when the appliance is
off.
1. Touch .
and "00" flash in the display.
2. Use or to set the MINUTE
MINDER. First you set the seconds,
then the minutes and the hours.
3. Touch and
reset the set time.
4. Touch or the MINUTE MINDER
starts automatically after five seconds.
When the set time ends, an acoustic signal
sounds for two minutes and 00:00 and
flash in the display.
5. Touch a sensor field to stop the
acoustic signal.
Setting the Time delay function
The DURATION
used at the same time, if the appliance is to
be switched on and off automatically later.
In this case, first set the DURATION
then the END function (refer to "Setting
the DURATION" and "Setting the END" ).
When the Time delay function is
activated, the display shows a
static symbol of the oven
function,
The dot shows which clock
function is on in the Clock /
residual heat display.
at the same time to
and END can be
with a dot and .
11
and