Scheppach HL730 Original Bedienungsanleitung Seite 48

11. Electrical connection
The electrical motor installed is connected and ready for operation.
The connection complies with the applicable VDE and DIN provisions.
The customer's mains connection as well as the extension cable used
must also comply with these regulations.
• The product meets the requirements of EN 61000-3-11 and is subject
to special connection conditions. This means that use of the product at
any freely selectable connection point is not allowed.
• Given unfavourable conditions in the power supply the product can
cause the voltage to fuctuate temporarily.
• The product is intended solely for use at connection points that
a) do not exceed a maximum permitted supply impedance "Z" (Zmax
= 0,354 Ω (230V) / 1,043 Ω (400V)), or
b) have a continuous current-carrying capacity of the mains of at least
100 A per phase.
• As the user, you are required to ensure, in consultation with your elec-
tric power company if necessary, that the connection point at which
you wish to operate the product meets one of the two requirements, a)
or b), named above.
Damaged electrical connection cable
The insulation on electrical connection cables is often damaged.
This may have the following causes:
• Passage points, where connection cables are passed through win-
dows or doors.
• Kinks where the connection cable has been improperly fastened or
routed.
• Places where the connection cables have been cut due to being driven
over.
• Insulation damage due to being ripped out of the wall outlet.
• Cracks due to the insulation ageing.
48 | GB
www.scheppach.com