ULTIMATE SPEED UMK 10 C2 Originalbetriebsanleitung Seite 35

Connect the connection valve
Read the air pressure on the display of the manometer
Remove the connection valve
use").
Note: The manometer
Attention: Please use a calibrated gauge if user needs an
accurate measurement.
Overload fuse
In the event of overuse or malfunction the overload fuse
in the cigarette lighter plug
Replace the fuse after resolving the reason for the fuse tripping
(see Fig. D).
Unscrew the tip of the cigarette lighter plug
remove the overload fuse
Insert the new overload fuse
cigarette lighter plug
5
Never use a fuse with a higher tripping current. Other-
wise, this poses a fire hazard!
(see "Initial use").
7
once more (see "Initial
7
is not calibrated.
2
will trip to protect the device.
5
and
5
.
11
and screw the tip of the
11
back on.
Cleaning
.
2
Never immerse the product in water or spray it with water.
Risk of injury due to electric shock if moisture enters the
device. Risk of injury due to electric shock if moisture
enters the device.
Do not use cleaners or solvents. These could damage
the product beyond repair.
Keep the vents
Clean with a damp cloth or a brush.
Maintenance
11
The product is maintenance-free.
Before and after each use, check the product and
accessories (e.g. accessory tools) for wear and damage.
If required, exchange them for new ones as described in
this instruction manual. Observe the technical requirements
(see "Technical data").
and the housing of the device clean.
3
GB/IE 35