ULTIMATE SPEED UMK 10 C2 Originalbetriebsanleitung Seite 34

Connecting with valve adapter
- Push the respective valve adapter into the opening in
the connection valve
- Secure the valve adapter into the connection valve
push clamping lever
Fig. C).
- Insert the valve adapter
(if necessary, first remove valve cover of the inflatable).
Switching on / off:
Switch the device on: on / off switch
Once the desired filling pressure has been reached,
switch the device off: on / off switch
Remove the cigarette lighter plug
Removing the connetion valve:
Connecting without valve adapter
ing lever for the connection valve
8
from the valve of the inflatable.
Connecting with valve adapter
adapter from the valve of the inflatable. Open the clamp-
ing lever of the connection valve
8
valve adapter .
10
34 GB/IE
:
10
.
7
toward connection valve (see
8
into the valve on the inflatable
10
to position "I".
6
to position "0".
6
.
5
: Open the clamp-
10
and remove
7
: Remove the valve
10
and remove the
7
Note: Air may escape from the valve of the inflatable when
removing the connection valve
the connection valve
:
7
The manometer
ble items where the wrong pressure can be dangerous
(e. g. car tires after a car breakdown), consult a special-
ized center with calibrated equipment and check the
pressure of the inflatable item.
Working instructions
This product is not suitable for continuous operation. It was
developed to produce air pressure, not air volume.
Do not use the product for longer than 5 minutes without
interruption to prevent overheating and damage to the
device. Afterwards allow to cool for a minimum of
20 minutes.
Checking the air pressure
Note: The device does not need to be connected to the
cigarette lighter to test air pressure.
. Be sure not to remove
7
too quickly.
7
is not calibrated. After inflating inflata-
2