Clean Air Optima RVC-002B Smart Gebrauchsanweisung Seite 5

19. Do not add liquids such as hot water, detergent or disinfectant as these may damage the
device.
20. Do not use this device in areas with open sockets or gas shutoff valves in the floor.
21. Do not use this device to pick up sharp objects, glass, or burning or smouldering objects.
22. Please note that the device moves on its own. Be careful when walking in areas where the
device is operating to avoid stepping on it.
23. If the device runs over and pulls a cord, it may pull objects off a table or shelf. Before using
this device, remove objects such as clothing, loose papers, blind or curtain cords, cords,
and fragile objects. Extinguish candles. Turn off electric heaters.
24. Perform required maintenance according to the user guide to ensure safe operation of the
device and charging station.
25. If using the device on a staircase, remove any debris from the top step.
26. Do not turn the robot over with the watertank in place.
27. This robot is intended for use on dry floors only. Do not use this appliance to vacuum up
spilled liquids. Do not allow the robot or charging station to get wet.
28. Do not place anything on top of the robot or charging station.
29. Failure to keep the charger contacts clean may result in the robot being unable to charge
the battery and the contacts becoming hot.
30. Before using the robot on a hard floor, test it on a small area of hard floor to ensure it is
suitable. Using the robot on an unsuitable hard floor may damage the floor. Contact the
manufacturer of the hard floor if you have any questions regarding suitability.
31. Before running the robot over carpet or rug, ensure that the carpet or rug is compatible
with the dual rubber brushes for all floor types on your robot, also known as rotating
brushes. Using the robot on an unsuitable carpet or rug may damage the carpet or rug.
Please contact the manufacturer of the carpet or rug if you have any questions about
compatibility.
32. .Use, maintain and clean the device as described in this manual.
Safety warnings self empty station
1. If the device is not working properly, has been dropped, damaged, left outside in all weather
conditions or has fallen into water, take the device to a service center.
2. Do not use a charging station with a damaged cord or plug. If the cord or plug is damaged, it
must be replaced
3. Always disconnect the robot from the charging station before cleaning or performing
maintenance on the robot.
4. Do not use the charging station as a step.
5. Only charge the robot using the supplied power supply. The supplied power supply provides
a safety extra low voltage according to the input voltage indication on the robot, which is
required to ensure safe operation.
6. To prevent your robot from falling down stairs, make sure that the charging station is at
least 1.2 meters away from the stairs.
7. Do not allow liquids to spill onto or into the charging station.
Safety warnings battery
1. Do not open, crush, heat above 80°C or incinerate the battery. Follow the instructions in the
user guide for proper use, maintenance, handling and disposal.
2. Do not short circuit the battery by allowing metal objects to come into contact with the
battery terminals or by immersing the battery in water. Do not subject batteries to
mechanical shock.
5