Clean Air Optima RVC-002B Smart Gebrauchsanweisung Seite 16

3. For a better mopping result, the floor should be vacuumed first, then start mopping.
4. To add water or clean the mop, first turn off the robot. Then reassemble the water tank.
Do not move or turn the robot, otherwise the positioning may fail, the map may be lost, and
the prohibited areas that have been programmed may disappear.
5. The mopping function of the robot is intended for wiping the floor and is not conducive to
thorough deep cleaning. Stubborn stains may not be removed effectively and will have to
be removed by hand.
6. Please do not use detergent in the water tank to prevent clogging.
7. Do not use the robot vacuum cleaner to remove water from the floor.
Maintenance main brush and side brushes
1. Turn the robot over and press the two clamps on the lid main brush to
open it and take the main brush out.
2. Remove the dust from the main brush using a small brush and clean
the main brush.
3. Put the main brush back into the robot and press the main brush and
cover firmly to close the clamps completely.
Clean the side brushes
1. Remove the side brushes by pulling them.
2. Remove hair and dirt with the cleaning brush
and put the side brushes back into the robot.
3. Make sure the left side brush (L) and the
right side brush (R) match L and R on the
bottom of the robot.
Maintenance dustbin and clean the dust bin
1. Press the dustbin release button to remove
the dustbin from the robot.
16
2. Open the lid to empty the dustbin and
clean it with the cleaning brush.
Cleaning brush