Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8. Voice and volume (APP control)
Set your preferred language and adjust the volume.
9. Do not disturb mode (APP control)
Here you can set a period of time in which the robot should not disturb you.
10. Set up virtual wall / restricted area (APP control)
Use this function to mark no-go zones in a room. For example, you can draw a virtual wall in
the map where the robot is not allowed to pass. Or you can create a prohibited area for
vacuuming and/or mopping in the map. You can start this function in the APP under the
device in the menu 'Map edit'.
Use watertank/ mop function
1. Stick the mop flat on the bottom
of the water tank.
3. Hold down the button in the middle of the
water tank and push it horizontally along the
back of the robot. The module is correctly
installed in place when you hear a "click".
5. When the robot has finished mopping, press
the button in the middle of the water tank.
This will allow you to remove the water tank
from the back, then empty the water tank and
clean the mop.
Caution: do not turn the robot over.
Water dosing (APP control)
Control the water dosage and choose between low, medium or high. This will regulate the
mop's wetness.
Mopping instructions
1. For safety reasons, you should remove the water tank when the robot is charging or not in
use.
2. Do not use the mopping function on carpets. Set a prohibited area via the APP to prevent
the robot from entering the carpet during mopping or temporarily remove the carpet.
2. Fill the water tank: open the water tank lid
and fill the water tank with water.
4. Start mopping the floor.
Press the clean button
robot.
on the
15
Werbung
