GOK Caramatic SafeDrive Montage- Und Bedienungsanleitung Seite 23

Fault cause
Abnormal flame pattern of
non-adjustable pressure
regulator
SHUT-DOWN
Close the gas supply and then the shut-off fittings of the connected consumer equipment.
When the LPG system is not in use, all valves must remain closed.
Close all free connections in the feed lines of the LPG system tightly with a
suitable cap to prevent gas from flowing out.
MAINTENANCE
Upon proper ASSEMBLY and OPERATION, the product is maintenance-free.
RESTORATION
If the actions described in TROUBLESHOOTING do not lead to a proper restart and if there is
no dimensioning problem, the product must be sent to the manufacturer to be checked. Our
warranty does not apply in cases of unauthorised interference.
REPLACEMENT
If there is any sign of wear or if the product or parts thereof are damaged, it must be replaced.
When the product has been replaced, observe the steps ASSEMBLY, LEAK TESTING and
START-UP.
To ensure that the installation works faultlessly under normal operating conditions, it is
recommended that you replace the device within 10 years of the date of manufacture.
Worn or damaged replaceable gaskets (if available) must be replaced upon reinstallation!
Make sure that the gaskets sit properly in the mounting and that the screws are tightened.
CERTIFICATE
Our management system is certified according to ISO 9001, ISO 14001 and
ISO 50001, see:
www.gok.de/qualitaets-umwelt-und-energiemanagementsystem.
TECHNICAL DATA
Maximum admissible pressure
Inlet pressure p
Nominal regulated pressure
Nominal flow rate M
ΔP = maximum permitted pressure drop
in the downstream installation
S2SR
Housing material
Ambient temperature
For additional technical data or special settings, see type label of the product!
Artikel-Nr. 71 835 50 a
Action
Compare the outlet pressure on the type label of the
pressure regulator with the inlet pressure of gas appliance:
 if they do not correspond, replace the pressure regulator
or the gas appliance.
g
PS 16bar
0.3 to 16bar
p alternatively 30 or 50mbar
d
1.5kg/h
5mbar bei p 30mbar
d
5mbar bei p 50mbar
d
100 or 150mbar
die-cast zinc ZP0410
-30°C to +60°C
Caramatic SafeDrive
23 / 60