Adjusting The Table Height - ATIKA ASP 6 L Betriebsanleitung

If you only release one control handle, then the splitting
blade remains where it is.
Special instructions for splitting logs:
Preparations:
The logs to be split should be cut to the maximum dimensions.
Ensure also that the logs are cut straight and square.
Place the log properly on the log splitter, so as not to cause any
risk of stumbling or falling to the operator.
Adjusting the stroke height
In case of shorter wood pieces the efficiency can be increased by
shortening the return of the splitting cutter.
1. Place the log on the
splitting table and
press the two control
handles to bring the
splitting blade down to
approx. 2 cm above
the log.
2. Release one control handle so that the blade stays in this
position.
3. Switch the machine off and disconnect the power.
4. Release the second control handle.
5. Shorten the return
path at the rod
fitted to the side
by fixing the
holding screw at
the necessary
height.
24

Adjusting the table height

Upper table plate position :
≈ 570 mm.
Middle table plate position :
≈ 820 mm.
Lower table plate position :
≈ 1035 mm.
1. Release the locking bolt.
2. Pull the table out.
3. Use the table in a position that comes close to the log
length and secure it with the locking bolt.
Holding
screw