Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 12
Adjusting the splitting cross:
fixing
1. Loosen
screw .
2. Move the splitting
cross
to
the
correct position
(The fixing screw
is
beyond
the
borehole in the
splitting blade).
fixing
3. Mount
screw .
Splitting short wood:
1. Upper position of table plate.
2. Place the log on the splitter's table plate.
3. Hold the log tight with the clamping claws.
Only split the logs in the direction of the wood fibres.
Splitting long wood:
1. Middle or low
position of table or
base.
2. Remove the
splitting cross.
3. Place the log on the
splitter's table.
Possible
malfunction
when
cleaving logs: The log
to be cleaved is not
cleaved right through,
jams on the cleaving
blade and is pulled up
during
the
blade's
return movement.
In this case, proceed
as follows:
1. Switch
off
the
device.
2. Depending on the
log
still
to
be
cleaved fix the table
plate in the middle
or upper position.
3. Switch
on
the
device and continue
the
splitting
operation.
Never try to split
two logs at once.
Never try to
remove or replace the
log during the splitting
process.
Fixing screw
Splitting cross
Never try to force the splitting of the log by maintaining the
pressure for several seconds. This can lead to damage to the
machine.
Position the log on the table again and repeat the splitting phase,
or put the log on one side.
How to release a jammed log?
There is a risk of knotted logs getting stuck during the splitting
process.
1. Switch machine off and disconnect the power.
2.
Do not remove jammed logs with your hands.
3. Carefully move the stuck log with a crowbar backwards and
forwards to loosen it. Don´t damage the splitting pillar.
Never hammer on the stuck log.
Never use a saw to cut the stuck log out of the machine.
Do not enlist the aid of a second person - this is a one-
man job.

Finishing work:

Bring the splitting blade to the lower position (run-in state).
Release one of the control handles.
Switch the machine off and disconnect the power.
Follow the care and maintenance instructions.
M
a
i
n
t
e
n
a
n
c
e
a
n
d
M
a
i
n
t
e
n
a
n
c
e
a
n
d
Before each maintenance and cleaning work:
− switch off device
− pull out main plug
Wear protective gloves in order to avoid injury to the
hands.
For maintaining and cleaning, removed security devices must
unconditionally be mounted properly and proved again.
Use only original parts. Other parts can result in unexpected
damages and injuries.
Be sure to have removed any tools from the machine after
completion of service work.
Maintenance and repair work other than those described in this
chapter is only allowed to be carried out by service staff.
To guarantee a long and reliable usage of the product carry out
the following maintainance works regularly.
Observe the following in order to keep the log splitter in
good working order:
Clean the machine thoroughly after you have finished
using it.
Remove any resin remains on the machine.
Check the device for obvious defects such as
-
Loose fastening elements
-
Worn out or damaged parts
-
Correct assembly and faultless covers and
protective devices
Lubricate the splitting column regularly or oil it using
environmentally friendly spray oil.
c
l
e
a
n
i
n
g
c
l
e
a
n
i
n
g
25

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis