Troubleshooting - Scheppach Haw2000 Original Bedienungsanleitung

21. Troubleshooting

The following table shows fault symptoms and describes remedial measures in the event of your device fails to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Device does not start
Motor stops during
operation
Possible cause
Damaged mains cable
On/off switch defective
Engine defective
Overheating protection
active
Engine defective
Damaged mains cable
www.scheppach.com
Remedy
Switch the device off and disconnect from the mains.
Check for mains connection cable for damage. If neces-
sary, have the mains connection cable replaced by an
authorised specialist.
Repair by an authorised service centre
Repair by an authorised service centre
Switch the device off and disconnect from the mains.
Allow the device to cool and then start the work process
again
Repair by an authorised service centre
Switch the device off and disconnect from the mains.
Check for mains connection cable for damage. If neces-
sary, have the mains connection cable replaced by an
authorised specialist.
GB | 27