Cleaning The Housing And Nozzles; Troubleshooting - Cleanmaxx Z 030644 Gebrauchsanleitung

EN
6. Allow all parts to dry completely in the air before you insert them again.
CAUTION! Do not under any circumstances use a hair dryer. Do not insert
the fi lter under any circumstances if it is still damp!
7. Place the fabric tape around the fi lter and close the Velcro fastener.
8. Place the fi lter back into the dust container so that it sits directly on the housing wall
all the way round.
CAUTION! Never use the vacuum cleaner without the fi lter inserted.
9. First place the dust container at the bottom of the device and then fl ip it shut. The
dust container must be fi rmly locked in place at the top and bottom of the device.

Cleaning the Housing and Nozzles

• Clean the housing if necessary using a damp, soft cloth. Dry it with a soft cloth.
• Remove hair and fl uff from the nozzles at regular intervals.
Storage

Troubleshooting

Should your device stop working properly at any time, exhibit signs of damage or require
a spare part, please contact the customer service department. For your own safety, do
not attempt to carry out repairs yourself.The following table contains tips on how you can
remedy small problems yourself.
Problem
The device does
not work.
20
• If you have attached the telescoping rod (13), you can
wind the cable over the two cable holders (1) for the pur-
pose of storage.
• Store the vacuum cleaner in a cool, dry place which is out
of the reach of children and animals.
Possible cause/solution/tips
• Is the plug not inserted in the mains socket correctly?
Insert the plug correctly.
• Is the mains socket defective? Try another mains socket.
• Check the fuse of your mains connection.