Beeper RVU-RR1 Installations- Und Bedienungsanleitung Seite 47

5. INSTALLING THE CAMERA
1. Drilling the hole
After determining the optimal location for the camera (see page 16), drill a hole in the bodywork for the cables to pass through.
We advise you to protect the support with an adhesive (painter's adhesive type) so as not to damage your bodywork during
drilling. Light sanding may be necessary after drilling the hole to deburr the outline of the hole.
2. Camera Installation
Once you have chosen the location, pass the cable through the drilled hole, then attach the camera using the special adhesive
provided in the kit. We advise you to reinforce this installation by creating additional waterproofing.
3. Creation of waterproofing
Once the camera is attached, carefully recreate the seal using sealant, so that water cannot enter the vehicle. If necessary,
reinforce the seal from the interior side, by adding a layer of body sealant.
/!\ Attention /!\
The use of sealant permanently seals the position of the camera, making it impossible to adjust the camera angle once
installation is finalized.
47