Led Work Light; Working Instructions - Parkside Performance Pabsp 20 Li C4 Bedienungsanleitung Und Originalbetriebsanleitung

˜ LED work light
This product is equipped with a LED
work light to illuminate the immediate
[ 11 ]
working area to improve visibility in poorly
lit areas .
The LED work light
o
automatically as soon as the product is
switched on .
NOTE
The LED work light
u
an additional approx . 10 seconds
after switching off the product.
˜ Working instructions
Torque
Smaller screws/bits can be damaged if
o
you set the torque or rotational speed
too high .
Hard screw joints (in metal)
Particularly high torque occurs, for
o
example in metal screw joints made
using drive sockets . Select a low
rotational speed .
Soft screw joints (e.g. in soft wood)
Again, use a low rotational speed, e .g .
o
to avoid damaging the surface of the
wood upon contact with the screw
head . Use a countersink .
Drilling in wood, metal and
other materials
Use a high speed for drill bits with
o
small diameter and a low speed for
drill bits with large diameter .
Select a low speed for hard materials
o
and a high speed for soft materials .
Secure or fasten the workpiece in a
o
clamp or vice (if possible) .
Mark the spot where you want to drill
o
using a centre punch or nail . Select a
low rotational speed when starting .
lights up
11 ] [
stays on for
11 ] [
Pull the rotating drill bit from the hole
o
repeatedly to remove dust and chips
and clear the hole .
Drilling in metal
Use a metal drill (HSS) . For optimum
o
results, cool the drill bit with cooling
lubricant (cutting oil) . Metal drill bits
can also be used to drill into plastics .
Start with a 3 mm diameter drill bit and
then increase the size until the desired
hole diameter is achieved .
Drilling in wood
Use a wood drill with a lathe centre .
o
Deep holes: Use an auger bit .
Large-diameter holes: Use a
Forstner bit .
Small screws can be screwed directly
into soft wood .
NOTE
The product is equipped with
u
an electronic safety function for
kickback control . During operations,
the product shuts down during use
if there is a sudden or unexpected
jamming and blockage . This
additional safety feature reduces the
chance of serious injuries .
After clearing the jamming and
u
blockage: The product automatically
turns back to normal .
Belt clip
(Fig . J)
CAUTION! Risk of injury!
m
Before hanging the product in the
u
belt: Push the rotation direction
switch to the centre position
5 ] [
(lock) . This prevents the product
from being switched on accidentally .
GB 19