Parkside Performance PABSP 20 Li C4 Bedienungsanleitung Und Originalbetriebsanleitung Seite 20

˜ Trial run
NOTE
Always carry out a no-load trial
u
run before starting work and after
every accessory tool replacement .
Switch the product off immediately
if the accessory tool is not running
smoothly, if considerable vibration
occurs or if you hear abnormal
noises .
Before operating the product,
o
check whether the accessory tool is
correctly positioned, i .e . centred in the
chuck .
1 ] [
Screw bits are labelled according to
o
their dimensions and their shape .
If you are uncertain, always check
whether the bit fits tightly in the screw
head without any free play .
˜ Operation
˜ Gear selection
ATTENTION! Risk of product
m
damage!
Do not operate the gear
selector
4 ] [
come to a standstill .
Change the gear by sliding the gear
o
selector forwards or backwards
[ 4 ]
(fig. F).
1 gear:
st
Suitable for:
Speed:
Torque:
2 gear:
nd
Suitable for:
Speed:
Torque:
18 GB
until the product has
Screwing
Low
High
Drilling
High
Low
˜ Setting the rotating direction
ATTENTION! Risk of product
m
damage!
Do not operate the rotation
direction switch
product has come to a standstill .
Change the direction of rotation
o
by pressing the rotation direction
switch towards the left or right
[ 5 ]
(fig. G).
When the rotation direction switch
o
is in the middle position, the on/off
switch is locked .
6 ] [
˜ Torque control
The torque can be adjusted by turning
o
the torque sleeve
Small screws or soft materials: Select
o
a low level .
Large screws, hard materials or
o
removing screws: Select a high level .
For drilling operation: Turn the torque
o
sleeve to the
[ 3 ]
˜ Switching on and off
NOTE
The on/off switch
u
locked .
Switching on: Press and hold the on/
o
off switch .
[ 6 ]
Regulate the speed as required (see
"Speed control") (fig. I).
Switching off: Release the on/off
o
switch .
6 ] [
˜ Speed control
By using the on/off switch
o
progressively control the speed:
Pressure
Gentle pressure:
Greater pressure:
until the
[ 5 ]
5 ] [
(fig. H).
[ 3 ]
position.
cannot be
[ 6 ]
, you can
6 ] [
Speed
Lower speed
Higher speed