Parkside Performance PABSP 20 Li C4 Bedienungsanleitung Und Originalbetriebsanleitung Seite 22

NOTE
The belt clip
u [ 9 ]
hooked on belt or pocket .
The belt clip is not assembled upon
u
delivery .
The belt clip can be mounted on
u
either side of a belt .
For the assembly of the belt clip a
u
cross tip screwdriver is required .
1 . Use a cross tip screwdriver to loosen
the screw of the belt clip
2 . Insert the belt clip on either side of
the product .
3 . Use a cross tip screwdriver to tighten
the screw .
˜ Cleaning and care
WARNING!
m
Always switch the product off,
remove the battery pack
and let the product cool down
before performing inspection,
maintenance and cleaning work!
˜ Cleaning
Never allow fluids to get into
o
the product .
The product must always be kept
o
clean, dry and free from oil or grease .
Remove debris from it after each use
and before storage .
Regular and proper cleaning will help
o
ensure safe use and prolong the life of
the product .
Clean the product with a dry cloth . Use
o
a soft brush for areas that are hard
to reach .
In particular clean the air vents after
o
every use with a cloth and soft brush .
The vents must always be clear .
o
20 GB
allows the tool to be
.
9 ] [
10 ] [
NOTE
Do not use chemical, alkaline,
u
abrasive or other aggressive
detergents or disinfectants to
clean this product as they might be
harmful to its surfaces .
˜ Maintenance
Before and after each use, check
o
the product and accessories (e .g .
accessory tools) for wear and damage .
If required, exchange them for new
ones as described in this instruction
manual . Observe the technical
requirements (see "Technical data") .
˜ Repair
This product does not contain any
o
parts that can be repaired by the user .
Contact an authorised service centre
or a similarly qualified person to have it
checked and repaired .
˜ Storage
Push the rotation direction switch
o
to the centre position to lock the on/off
switch .
[ 6 ]
Clean the product as described above .
o
Store the product and its accessories
o
in a dark, dry, frost-free, well-
ventilated place .
Always store the product in a place
o
that is inaccessible to children . The
ideal long term storage (longer than
3 months) temperature is between +20
and +26 °C .
Guide the drill bit into the bit holder
o
Store the product in its carrying
o
case .
[ 19 ]
Battery pack advice
Only store the battery pack
o
charged . The battery pack should be
charged to 40 to 60 % (red and orange
LED in the charge indicator
before storing for extended periods .
5 ] [
.
8 ] [
partially
10 ] [
light up)
14 ] [