Werbung
◾
Before using, always visually inspect to see that the
EN
blades, blade bolt and cutter assembly are not worn or
damaged. Replace worn or damaged blades and bolts
in sets to preserve balance.
Operation
◾
Edge only in daylight or in good artificial light.
◾
Always be sure of your footing on slopes.
◾
Walk, never run.
◾
Use extreme caution when reversing or pulling the edger
toward you.
◾
Make sure the blade has stopped before crossing
surfaces other than grass and when transporting the
edger to and from the area to be edged.
◾
Never operate the edger with defective, missing or
incorrectly fitted guards.
◾
Do not change the motor governor settings or
overspeed the motor.
◾
Start the switch on the motor carefully according to
instructions and with feet well away from the blade(s).
◾
Do not tilt when switching on the motor, unless the edger
has to be tilted for starting. In this case, do not tilt it more
than absolutely necessary and lift only the part which is
away from the operator.
◾
Do not start the motor when a bystander is standing in
front of the blade(s).
◾
Do not put hands or feet near or under rotating parts.
◾
Always switch off the motor and disconnect from the
battery:
1) Before clearing blockages;
2) Before checking, cleaning or working on the blade(s);
3) After striking a foreign object: Inspect the blade(s)
for damage and make repairs before restarting and
operating the edger;
4) If edger starts to vibrate abnormally (check
immediately).
◾
Stop the motor whenever you leave the edger;
◾
Do not charge the battery pack in rain, or in wet locations.
◾
Use only with battery packs and chargers listed in fig.A
◾
The battery pack must be removed from the appliance
before it is scrapped.
◾
The battery shall be disposed of safely.
◾
Do not dispose of the battery in a fire. The cells may
explode. Check with local authorities for possible special
disposal instructions.
◾
Do not open or mutilate the battery. Released electrolyte
is corrosive and may cause damage to the eyes or skin. It
may be toxic if swallowed.
8
EDGER ATTACHMENT — EA0800
◾
Exercise care in handling batteries in order not to short the
battery with conducting materials such as rings, bracelets,
and keys. The battery or conductor may overheat and
cause burns.
◾
Battery tools do not have to be plugged into an
electrical outlet; therefore, they are always in operating
condition. Be aware of possible hazards even when
the tool is not operating. Take care when performing
maintenance or service.
◾
Do not wash with a hose; avoid getting water in motor
and electrical connections.
Maintenance and storage
◾
Keep all nuts, bolts and screws tight to be sure the
equipment is in safe working conditions.
◾
Replace worn or damaged parts.
◾
Do not attempt to repair the machine unless you are
competent to do so.
◾
Use only manufacturer-recommended replacement
parts and accessories.
◾
Disconnect the machine from the battery before
carrying out maintenance or cleaning work.
◾
Inspect and maintain the machine regularly. Have the
machine repaired only by an authorized repairer.
◾
When not in use, store the machine out of the reach
of children.
◾
If situations occur that are not covered in this manual,
use care and good judgment. Contact the EGO Service
Center for assistance.
◾
Save these instructions. Refer to them frequently and
use them to instruct others who may use this tool. If
you loan this tool to someone else, also loan these
instructions to them to prevent misuse of the product
and possible injury.
SAVE THESE INSTRUCTIONS
NOTE: SEE YOUR POWER HEAD OPERATOR'S
MANUAL FOR ADDITIONAL SPECIFIC SAFETY RULES.
SPECIFICATIONS
Blade Length
Edging Depth
Weight
Operating Temperature
Storage Temperature
20 cm
Up to 75 mm
2.26 kg
-15°C-40°C
-20°C-70°C
Werbung
