Copper Power Supply - TREND Multipro Copper Kurzbedienungsanleitung

1. Switch Trend Multipro off.
2. Remove the Copper PIM from Trend Multipro. See the Main Refer-
ence Guide for information on how to remove a PIM.
3. Insert the point of the stylus into the cable release hole, of the ca-
ble you want to remove, and keep the stylus in the hole.
4. Pull to remove the testing cable.
5. Remove the stylus from the hole.
Repeat the above steps to remove the second testing cable if more than
one is connected.
To remove the cables without removing the PIM from the Multipro, you can
use the supplied Copper PIM Probe Cable Release Tool (405487) as
shown below.
1

Copper Power Supply

The Trend Multipro Copper Power Supply, provided with the Copper PIM,
has a 3-pin mains electricity plug and MUST be plugged into an earthed
mains electricity socket.
For optimum performance, use either the Trend Multipro Copper Power
Supply or use battery power.
Multipro Copper
Short User Guide
2
-8-
3
405801 Iss 3