Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.
Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new device brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability
laws, the manufacturer of this device assumes no lia-
bility for damage to the device or caused by the device
arising from:
• Improper handling,
• Non-compliance with the operating manual,
• Repairs carried out by third parties, unauthorised
specialists,
• Installing and replacing non-original spare parts,
• Improper use,
• Failures of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE 0113 not being observed.
Our recommendation to you:
The operating manual is part of this product.
It includes important instructions for the safe, proper
and economic operation of the product, for avoiding
danger, for minimising repair costs and downtimes and
for increasing the reliability and extending the service
life of the product. In addition to the safety instructions
in this operating manual, you must also observe the
regulations applicable to the operation of the product
in your country.
Familiarise yourself with all operating and safety in-
structions before using the product. Only operate the
product as described and for the specified areas of ap-
plication. Keep the operating manual in a good place
and hand over all documents when passing the product
on to third parties.
2. Product description (Fig. 1-5)
1.
Motor housing
2.
On/off switch
3.
Locking switch
4.
Handle
5.
Oil filler hole/sight glass
6.
Additional handle
20 | GB
7.
Tool receiver
8.
Locking bolts
9.
Clamping screw
3. Scope of delivery (Fig. 1)
Item
A
B
C
D
E
4. Proper use
The electric tool is intended for heavy chisel and dem-
olition work and also for driving in and compacting with
the appropriate accessory.
The product is suitable for chiselling into the follow-
ing materials:
• Concrete
• Masonry
• Stone
• Plaster
• Tiles
The product may only be used in the intended manner.
Any use beyond this is improper. The user/operator, not
the manufacturer, is responsible for damages or inju-
ries of any type resulting from this.
An element of the intended use is also the observance
of the safety instructions, as well as the assembly in-
structions and operating information in the operating
manual.
Persons who operate and maintain the product must be
familiar with the manual and must be informed about
potential dangers.
The liability of the manufacturer and resulting damages
are excluded in the event of modifications of the prod-
uct.
www.scheppach.com
Quantity
Designation
1x
Demolition hammer
1x
Flat chisel
1x
Pointed chisel
1x
Socket spanner SW23
1x
Oil bottle
2x
Carbon brush
1x
Transport case (not shown)
1x
Operating manual
Werbung
