Fox TRANSFER NEO Bedienungsanleitung Seite 8

PAIR THE TRANSFER NEO SYSTEM TO THE RIDE FOX BIKE APP
The Ride FOX Bike App is required to get the latest firmware updates and is
strongly recommended. The seatpost can be setup and used with or without
the App.
1. Open the Ride FOX Bike App on your mobile device.
2. Create your account.
3. Follow the instructions to pair your controller to the App.
4. The App will now guide you through proper setup and pairing for your Transfer
Neo system and help you monitor the battery life, update firmware, and
actuate the seatpost when necessary.
PAIR THE REMOTE LEVER TO THE CONTROLLER
Use the Ride FOX Bike App to walk you through this
procedure, or follow the steps below.
1. Make sure the controller battery is charged and
installed onto the controller.
2. Press the pairing button on the remote lever. A
green LED will begin flashing on the remote lever
(see Figure E).
3. Press the pairing button on the controller. A green
LED will begin flashing on the controller (see
Figure F).
4. After a few seconds, the LEDs will turn solid green,
indicating the controller and remote lever have
located each other.
5. Only after you see the LEDs turn solid green (not
flashing), press the pairing button on the controller
again to accept the pairing. A quick green LED flash
on both the remote lever and controller, which will
confirm a successful pairing.
E
F
Pairing button
8
Pairing button