Connecting The Aerial; Connecting The Line Outputs; Aux In Connection - Renkforce SD-3023 Bedienungsanleitung

Electric Connection

Connecting the aerial

• Connect the aerial plug of your vehicle with the aerial socket at the back of the radio (socket next to the Cinch
terminals).
• If your vehicle has a different aerial plug, please use a suitable adapter, available in specialist shops.

Connecting the LINE outputs

The SD tuner has four LINE outputs for connecting a power amplifier.
For the connection of the cinch sockets only use the shielded cinch wires. The use of other
cables might cause interferences.
Keep the distance of the cables as short as possible.
Do not place the cables near other cables to avoid interferences in the cables.
To avoid distortions or mismatchings that could damage the unit, the cinch connector must
only be connected to devices with the suitable cinch terminals. For this, observe also the
connection data in the section "Technical Data".
• Connect the Cinch sockets on the back of the radio to the power amplifier's input.

The red socket is a terminal for the right channel
The white socket is a terminal for the left channel

AUX IN connection

You can connect an external audio device (e.g. portable MP3 player) to the port AUX IN (22) whose signal is played
back via the vehicle loudspeakers.
• Connect the port AUX IN (22) with the audio output of the external device.
45