Connecting The Aerial; Connecting The Line Outputs; Aux Connection - Renkforce RUCD-1804 Bedienungsanleitung

In most vehicles, the cables for the electric connection and the connection of the speakers have been laid
directly to the slot.
If this is not the case, please make sure that any cables placed later are secured by the respective on-board
fuses (see vehicle operation manual).
a) Connecting the Aerial
• Connect the aerial plug of your vehicle with the aerial socket at the back of the radio.
• If your vehicle has a different aerial plug, please use a suitable adapter, available in specialist shops.
b) Connecting the LINE Outputs
The car radio has LINE outputs for connecting a power amplifier.
For the connection of the cinch sockets only use the shielded cinch wires. Use of any other cables
may cause interferences.
Keep the distance of the cables as short as possible.
Do not place the cables near other cables, to avoid interferences in the cables.
To avoid distortions or mismatching that could damage the device, cinch connector must only be
connected to devices with the suitable cinch terminals.
Connect the cinch sockets at the rear of the casing to the power amplifier inputs.
The red socket is a terminal for the right channel
The white socket is a terminal for the left channel
c) AUX Connection
You can connect an external audio device (e.g. portable MP3 player) to the port AUX (19) whose signal is played
back via the speakers.
Connect the port AUX (19) with the audio output of the external device.
35