Installing The Drip Tray - WIK 9752 D Bedienungsanleitung

Commissioning
■
An extension lead that may be used for connection of the appliance
to the mains power supply must be uncoiled and must have a length
of not more than 3 metres and a cross-section of 1.5 mm². The use of
multiway adapters or multiple socket outlets is forbidden due to the
associated fire hazard.
■
The connecting lead must not be strained.
■
The
nected to a properly installed protective earth (PE) conductor system.
Connection to a plug socket without PE conductor is forbidden. If in
doubt, have the house installation checked by a qualified electrician.
The manufacturer assumes no liability for injury or damage caused by
a missing or interrupted protective earth conductor.

Installing the drip tray

Before using the grind and brew coffee maker, the drip tray must be in-
stalled and the appliance connected to the power supply. Proceed as
follows:
Push in the drip tray until it engages on the right under the water
‹
tank.
Connect the appliance to the mains power supply, then open the flap
‹
of the cable storage compartment and stow the remaining connecting
lead.
electrical safety of the appliance is only assured when it is con-
GB
93