WIK 9752 D Bedienungsanleitung Seite 115

Operation and function
Remove the jug from under the steam nozzle.
‹
WARNING
Risk of scaling from splashing hot milk!
►
Switch off the steam nozzle before you remove the jug with the
foamed milk.
Quit steam mode by pressing button (B) or wait approx. 60 seconds
‹
until the appliance switches automatically back to the selection menu
(coffee mode) and the display goes out. The appliance is now ready
for coffee preparation again. The last coffee/espresso setting selected
appears on the display.
NOTE
►
Always allow hot water to run through the nozzle briefly after fo-
aming the milk. Turn the rotary switch "hot water/steam" (17) to po-
sition
dry inside the nozzle and clog the nozzle. Use a suitable collecting
vessel for this. Then turn the rotary switch back to position
last coffee/espresso setting selected appears on the display.
To clean the foaming attachment, proceed as follows:
After every foaming, remove the foaming attachment as follows:
‹
. This is recommended so that any milk residues cannot
1.
2.
GB
. The
115