Grundfos SEG AUTOADAPT Serie Anleitung Seite 49

UK Declaration of Performance
GB: Declaration of performance
UK declaration of performance in accordance
with The Construction Products Regulation 2019
1. Unique identification code of the product type:
• EN 12050-1
2. Type, batch or serial number or any other element
allowing identification of the construction product as
required pursuant to Article 11(4):
• SEG AUTOADAPT pumps marked with EN 12050-1
on the nameplate.
3. Intended use or uses of the construction product, in
accordance with the applicable harmonised technical
specification, as foreseen by the manufacturer:
• Pumps for pumping of wastewater containing faecal
matter marked with EN 12050-1 on the nameplate.
4. Name, registered trade name or registered trade mark
and contact address of the manufacturer as required
pursuant to Article 11(5):
• Grundfos Holding A/S
Poul Due Jensens Vej 7
8850 Bjerringbro
Denmark.
5. NOT RELEVANT.
6. System or systems of assessment and verification of
constancy of performance of the construction product as
set out in Annex V:
• System 3.
7. In case of the declaration of performance concerning a
construction product covered by a designated standard:
• TÜV Rheinland LGA Products GmbH, identification
number: 0197.
Performed test according to EN 12050-1 under
system 3.
(description of the third-party tasks as set out in
Annex V)
• TÜV Rheinland LGA Certificate or Test Report
number: 60139390.
Type-tested and monitored.
8. NOT RELEVANT.
9. Declared performance:
The products covered by this declaration of performance
are in compliance with the essential characteristics
and the performance requirements as described in the
following:
• Standards used: EN 12050-1:2001, EN 12050-1:2015
and EN 12050-1:2015.
10 The performance of the product identified in points 1 and
. 2 is in conformity with the declared performance in point
9.
49