Parameter Setup; New Password - Quick Tools Quick 707D+ Bedienungsanleitung

2.9. Parameter Setup

1) The password is entered correctly to access the parameter menu. The
sequence of changes is shown in the following figure.
2) Click "▲" or "▼" button to select parameter menu -1- and return to the main
menu directly; after selecting parameter menu -2-, press "▲" and "▼" button
to enter the new password setting.
2.10.
1) After entering the new password setting, the window displays "---" and the
hundreds' digit flashes.
2) Then adjust the middle knob to change the hundreds' digit, press the "▲"
button to move the digit, and then the tens' digit will start flashing to be set,
and the tens and units' digits will be set in the same way as the hundreds' digit.
When the digit is set, press and hold the "▲" and "▼" buttons at the same time
to confirm. Enter the password for the second time. The second password
setting method is the same as the first password setting input.
Note: If the numbers of the password entered twice before and after are not
the same, the window will show "ERR", which means the password setting is
not successful, return to the parameter setting, and the password will remain
unchanged.
If the same number is entered twice, the window will show "OK", which means
the password is set successfully and return to the parameter setting. Turn off
and restart the computer, and the encryption will take effect.

New Password

8
USER MANUAL