Password Setup - Quick Tools Quick 707D+ Bedienungsanleitung

USER MANUAL

2.8. Password Setup

The initial password of the rework station is "000", in which the temperature
can be set. If you need to limit the temperature adjustment, you must change
the password.
Enter password setting mode
1) Turn off the station press the "▲" and "▼" buttons on the right side at the
same time, and then turn on the station.
2) Press and hold the "▲" and "▼" buttons on the right side. After a beep, the
display will show C, and the menu will then pop up with the display "- - -".
3) After entering the correct password, go to the parameter setting.
Enter the initial password
1) The window displays "- - -" and the leftmost hundreds' digit flashes, at this
time the hundreds' digit can be adjusted (i.e., the initial password can be
entered）.
2) Enter the initial password: adjust the middle knob to change the hundreds'
digits, press the "▲" button on the right to move the digits, and then the tens'
digit start flashing and can be set, and the tens' and units' digits are set in the
same way as the hundreds' digits. When the digit is set, press and hold the "▲"
and "▼" buttons at the same time to confirm.
3) If the first password is wrong: it will go directly to the second entry of the
password, the method of second entry of the password is the same as the first
time. (There are two chances to input the password. If the first password is
entered incorrectly, you can go directly to the second entry.）
4) If the password entered twice is wrong: the window will show "ERR",
and then directly enter the main menu.
5) If the password entered for the first or second time is correct: Then
directly enter the parameter setting and the window will show "-1-".
7