ACD GRUPPE M2Smart SE Kurzübersicht Seite 33

The table below describes the LED behavior of the M2Smart
LED Status
LED 1: ON LED
Off
Green
Green/flashing
Red/flashing
LED 2: Charge LED
Off
Red/flashing slow
Red/flashing fast
Yellow/flashing
Yellow
Blue
LED 3: Application LED
Colors: red/green/blue
Mixture: yellow/turquoise/
purple/white
19.2 Connection Set
®
The M2Smart SE 10 Inch and the Active mounting bracket may only be operated with the corresponding
power supply unit and DC connection cable.

External power supply unit for the M2Smart
o
Input voltage ~ 100 - 240 V AC; 1.0 A max.; 50 - 60 Hz
o
Output voltage

DC connection cable:
o
Length corresponds to 5 m
o
Sheath: TPU
o
Input voltage:
Power Supply!)
o
Connection assignment according to wire numbering: no.1 "+ (15/24 V DC)" and no.2 "- (0 V
DC)"
The M2Smart
voltage range using the DC connection cable. A deviation in the
voltage can lead to the destruction of the M2Smart
ATTENTION
®
M2Smart SE 10 Zoll_M2Smart
Meaning
Device switched off
Normal operation
Idle mode
Flash process, system update
No external supply, battery status normal
Battery operation, status low
Battery operation, critical condition
Battery status unknown
Battery charging, externally supplied
Firmware update
Application LED
15 V DC; 2.4 A
15/24 V DC (+/- 15 %) (Before commissioning, observe section 18.1
®
SE 10 Inch may only be supplied with the specified
®
SE_10 Inch_Kurzübersicht_Brief Overview_V1.00_de_en
®
SE 10 Inch:
®
SE 10 Inch and active mounting bracket
®
SE 10 Inch.
33 / 44