Connecting To A Network - Dedicated Micros digital sprite Einrichtungsanleitung

Connecting multiple external devices
Up to seven storage devices can be daisy chained from the SCSI port on the rear
of the Digital Sprite. Each device must have a unique address and the last device
on the chain must be terminated, check with the device documentation for
details of addressing and termination.
Note: Only one tape drive can be connected to the SCSI bus.
The table below gives capacity and typical uses of each storage device.
External storage Capacity
RAID Currently up to
375GB*
Iomega Zip® 100 or 250MB
Iomega Jaz® 1 or 2GB
Hewlett Packard 12GB
DDS-3
Hewlett Packard 20GB
DDS-4
Ecrix VXA 20GB
* Single RAID capacity, up to 7 RAIDs can be connected to Digital Sprite.
8
Description Typical use
Disk array with Longer term storage
fault tolerance with instant access
Removable media Event or clip storage
Removable media Event or clip storage
Digital storage tape Long term
tape-a-day archive
Digital storage tape Long term
tape-a-day archive
Robust Digital Long term
storage tape tape-a-day archive

Connecting to a network

Digital Sprite can be used to distribute high quality live or recorded images across
standard TCP/IP networks to a viewer's desktop PC – where images can be viewed
using a standard web browser.
Digital Sprite is available with or without network video capabilities. Units with
video network capabilities can be identified by the word 'NET' appearing after the
software version in the menu.
Note: Units without network video capabilities can still connect to a network but
only for upgrade purposes. Contact your local office for details of upgrading
Digital Sprite for video networking.
To view images across a network you will need:
• A valid IP address, Default gateway, and Subnet mask for the Digital Sprite.
These are usually obtained from your network administrator.
• A PC connected to the network with a minimum specification of:
200 MHz CPU.
64MB RAM.
4MB Video card (capable of displaying 16 million colours).
Microsoft ® Windows ® 95, 98, or NT, or MacOS 7.5.
• A spare 10-baseT Ethernet port on the network.
• An RJ-45 network cable for connection between the Digital Sprite and
the network.
• Microsoft Internet Explorer 5.X (PC) or Netscape Navigator 4.X (PC and Mac).