Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Appendix 3
Configuring JVC and Ultrak domes
JVC (TK-C675BE)
The switch settings (S1) should be set to:
Disp
ON
Multi-drop
ON
Simplex
ON
Sync
INT
The Data A and B are connected to RS-485 + and - respectively.
Ultrak (UltraDome™ KD6)
The switch settings (S4) should be set to:
Switch 1
ON
Setting up JVC or Ultrak domes
The *command key is used to enter or exit the setup menus on JVC or Ultrak domes.
1. Press the *command key to enter the dome menu. The dome menu is
displayed on the main monitor and a
to indicate that the keyboard is controlling the dome menu.
2. Use the joystick to navigate the dome menu.
3. Press 'Enter' to select a menu item.
4. Select 'Exit' to leave the Ultrak menu, or press and hold the *command key to
exit each menu level on the JVC dome.
5. Press and hold the *command key to remove the
and return control of the Digital Sprite.
Note: If the dome menu is not displayed, but the
hold the *command key again.
Check the dome manufacturer's documentation for details of connections,
camera addresses, and setup information.
is displayed next to the time and date
from the main monitor
is still on screen, press and
Additional functions for the Ultrak dome
Functions which cannot be accessed directly from the remote keyboard can be
accessed using the 'Preset' command.
Recalling a preset
1. Press the 'Preset' key – a pop-up box appears.
2. Enter the two digit preset number using the camera keys. Camera 10 denotes
number 0. For example, preset 80 should be entered as camera 8 and 10.
3. The pop-up box disappears and the camera will move to the preset position.
Preset number
Function
80
Run tour 1
81
Run tour 2
82
Run tour 3
83
Program tour 1
84
Program tour 2
85
Program tour 3
86
Terminate tour programming
87
Run patrol 1
88
Run patrol 2
89
Run patrol 3
90
Start menu (same as *command key)
92
Toggle auto exposure
93
Toggle backlight compensation
95
Decrease goto preset speed
96
Increase goto preset speed
25
Werbung
