AEG CW10 Bedienungsanleitung Seite 26

26 www.aeg-automotive.com
No. Description
"Charging" LED
"Charged" LED
"Repair" LED
8
"Error" LED
"Reverse Polarity" LED
9 Charging voltage LEDs
10 MODE button
11 Battery type LEDs
12 "Type" button
13 Charging current LEDs
14 "Rate" button
15 "Start/Stop" button
16 "TEST" button
17 Alternator LEDs
Functions
The charger is equipped with a microprocessor
(MCU - Micro Computer Unit) and features fully
automatic diagnostic, charging, and maintenance
functions. If the wrong battery voltage is selected
or the battery is defective, it will not charge and the
"Error" LED (8) or "Reverse Polarity" LED (8) will
light up (also see "Troubleshooting").
The "trickle charge" function allows the charger
to be permanently connected. A full charge will be
maintained.
Function
lights up during charging.
lights up when the battery is fully charged.
lights up during repair.
lights up if an error occurs.
lights up if the polarity of the clamps connected to the battery is
reversed.
indicate the selected charging voltage.
to select the charging voltage.
Indicate the selected battery type.
to select the battery type.
indicate the selected charging current.
to select the charging current.
to start/stop the charging process or to jump start.
to start testing the alternator.
Alternator status display
The "Power Supply" function supplies your vehicle
with a constant voltage of 13.6 whilst working on the
electronics or changing the battery.