Electrolux COB8S09X Benutzerinformation Seite 48

12.1 What to do if...
Problem description
You cannot activate or operate the
appliance.
The appliance does not heat up.
The lamp is turned off.
Power cut always stops cleaning. Repeat cleaning if it's interrupted by power failure.
12.2 Error codes
When the software error occurs, the display shows error message. You will find the list of
problems in the table below.
Code and description
F111 - Food Sensor is not correctly inserted into the
socket.
F240, F439 - the touch fields on the display do not
work properly.
F908 - the appliance system cannot connect with the
control panel.
12.3 Service data
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre.
The necessary data for the service centre is
on the rating plate. The rating plate is located
on the front frame of the appliance. It is
visible when you open the door. Do not
remove the rating plate from the appliance.
48 ENGLISH
Cause and remedy
The appliance is not connected to an electrical supply or it is connected in‐
correctly.
The clock is not set.
To set the clock refer to "Clock functions" chapter.
The door is not closed correctly.
The fuse is blown.
Make sure the fuse is the cause of the problem. If the problem recurs, con‐
tact a qualified electrician.
Child Lock is activated.
The lamp is burnt out. Replace the lamp.
For details refer to "Care and Cleaning" chapter.
Remedy
Fully plug Food Sensor into the socket.
Clean the surface of the display. Make sure there is no
dirt on the touch fields.
Turn the appliance off and on.
We recommend that you write the data
here:
Model (MOD.) :
Product number (PNC):
Serial number (S.N.):