Electrolux COB8S09X Benutzerinformation Seite 46

appliance when the hard reminder is on,
the steam functions are disabled.
11.7 Rinsing
Use it to clean the steam system after
frequent use of the steam functions.
1. Turn off the appliance and wait until it is
cold.
2. Remove all accessories.
3. Place the deep pan on the first shelf
position.
4. Fill the water drawer with water to the
maximum level until the signal sounds or
the display shows the message.
5. Select: Menu / Cleaning / Rinsing.
Duration: around 30 min
6. Turn on the function and follow the
instruction on the display.
7. When the function ends, remove the deep
pan.
When this function works, the lamp is off.
11.8 Drying
Use it after cooking with a steam heating
function or steam cleaning to dry the cavity.
1. Turn off the appliance and wait until it is
cold.
2. Remove all accessories.
3. Select: Menu / Cleaning / Drying.
4. Follow the instruction on the display.
11.9 Drying reminder
After cooking with a steam heating function
the display prompts to dry the appliance.
Press YES to dry the appliance.
11.10 Tank emptying
Use it after cooking with steam heating
function to remove the residual water from
the water drawer.
1. Turn off the appliance and wait until it is
cold.
2. Remove all accessories.
3. Place the deep pan on the first shelf
position.
4. Select: Menu / Cleaning / Tank emptying.
Duration: 6 min
46 ENGLISH
5. Turn on the function and follow the
instruction on the display.
6. When the function ends, remove the deep
pan.
When this function works, the lamp is off.
11.11 Removing and installing the
door
You can remove the door and the internal
glass panels to clean it. The number of glass
panels is different for different models.
WARNING!
The door is heavy.
CAUTION!
Carefully handle the glass, especially
around the edges of the front panel. The
glass can break.
1. Fully open the door.
2. Press the clamping levers
door hinges.
A
3. Close the oven door to the first opening
position (at approximate angle: 70°).
4. Hold the door with one hand on each side
and pull it away from the oven at an
upwards angle.
5. Put the door with the outer side down on
a soft cloth on a stable surface.
6. Hold the door trim
the door at the two sides and push
inwards to release the clip seal.
on the two
A
on the top edge of