Electrolux COB8S09X Benutzerinformation Seite 34

150°C
85°C
15min
F E D C
A. Time of Day
B. START / STOP
C. Temperature
D. Heating functions
E. Timer
F. Food Sensor (selected models only)
Display indicators
To confirm the selection / setting.
5. BEFORE FIRST USE
WARNING!
Refer to Safety chapters.
5.1 First connection
The display shows welcome message after
the first connection.
You have to set: Language, Display
Brightness, Key Tones, Buzzer Volume,
Water Hardness, Time of Day.
5.2 Initial preheating and cleaning
Preheat the empty appliance before the first
use and contact with food. The appliance can
emit unpleasant smell and smoke. Ventilate
the room during preheating.
1. Remove all accessories and removable
shelf supports from the appliance.
2. Set the function
temperature. Let the appliance operate
for 1 h.
3. Set the function
temperature. Let the appliance operate
for 15 min.
4. Turn off the appliance and wait until it is
cold.
34 ENGLISH
A
12:30
START
B
. Set the maximum
. Set the maximum
Display indicators
To go one level back in the menu.
To undo the last action.
To turn the options on and off.
The sound alarm function is activated.
The sound alarm and stop cooking function
is activated.
Pop up message only is activated.
Delayed start function is activated.
To cancel the setting.
5. Clean the appliance and the accessories
only with a microfibre cloth, warm water
and a mild detergent.
6. Put the accessories and removable shelf
supports back to their initial position.
5.3 Setting: Water Hardness
When you connect the appliance to the mains
you have to set the water hardness level.
Use the test paper supplied with the steam
set.
1. Put the test paper into water for about 1
sec. Do not put the test paper under
running water.
2. Shake the test paper to remove any
remaining water.
3. After 1 min, check water hardness with
the table below.
4. Set the water hardness level: Menu /
Settings / Setup / Water Hardness.
The colours of the test paper continue to
change. Check the water hardness within 1
min after testing.
You can change the water hardness level in
the menu: Settings / Setup / Water Hardness.