Renkforce Pro 10+ Bedienungsanleitung Seite 54

12 Printing
12.1 Using Cura
Cura is an open-source slicing software compatible with the Pro 10+.
If you want to print with Cura, follow to the setup instructions in
12.2 Printing from USB memory stick
1. Save the print file that contains the model to the supplied USB memory stick.
2. Connect the USB memory stick to the USB-A port on the printer.
3. Select the print file from the print menu.
4. Print the file.
The printer will sound an alarm after printing is complete.
Æ
5. After printing is complete, flip the power switch into the position 0.
6. Let the printer cool down to room temperature.
12.3 Printing from computer via USB cable
After connecting the computer to the printer via USB cable, you can print 3D models
directly from the slicing software (example: Ultimate Cura).
1. Connect the USB cable to the USB-B port on the printer.
2. Connect the USB cable to a USB port on the computer.
3. Start the print job in the slicing software.
The printer will sound an alarm after printing is complete.
Æ
4. After printing is complete, flip the power switch into the position 0.
5. Let the printer cool down to room temperature.
54
12.4 Printing from computer via Wi-Fi connection
After connecting the computer and the printer via Wi-Fi, you can print 3D models di-
rectly from the slicing software (example: Ultimate Cura).
1. Set up and configure Wi-Fi by following the Wi-Fi setup instructions in
ting up Wi-Fi printing ].
[ ►14 Setting up Cura ].
2. Start the print job in the slicing software and wait for it to complete.
The printer will sound an alarm after printing is complete.
Æ
3. After printing is complete, flip the power switch into the position 0.
4. Let the printer cool down to room temperature.
12.5 Removing printed models
1. Flip the power switch into the position 0.
2. Let the printer cool down to room temperature.
3. Remove the magnetic mat with the printed object.
CAUTION
Hot print bed
Touching hot print bed can cause burns
Let cool down before touching
[ ►13 Set-