Werbung
Verfügbare Sprachen
Verfügbare Sprachen
16.2 Replacing the fuse
1. Remove the mains cable from the power inlet on the printer.
2. Pry open the fuse box. See Fig. 4.
3. Remove the blown fuse.
4. Insert a new fuse of the same specifications.
5. Close the fuse box.
6. Connect the mains cable to the power inlet on the printer.
Fig. 4
64
17 Storage
1. Disconnect the power supply.
2. Unload the filament.
3. Clean the printer.
4. Let the printer cool down to room temperature.
5. Store the printer in a dry, dust-free location out of the reach of children.
Note:
PLA filaments will over time absorb moisture and dust when exposed to the open
air, which can affect the printing quality. Seal the filament in an air-tight container
when not in use.
Werbung
