Renkforce Pro 10+ Bedienungsanleitung Seite 52

Slide the paper back and forth while repeatedly touching the button
bed up. As soon as you notice slight resistance between nozzle, paper, and print bed
touch the button Stop interrupt.
After calibration
1
After you have calibrated each of the 4 calibration points:
1. Calibrate the Z-offset. Follow the instructions in
2. Level the print bed using "Auto-levelling". Follow the instructions in
"Auto-levelling" to level the print bed ].
52
Level each of the four indicated calibration points individually.
to lift the print
Touch the buttons
For each calibration point, slide the paper back and forth while turning the calibration
screw under the print bed. Stop turning the screw as soon as you notice slight resist-
ance between nozzle, paper, and print bed.
[ ►11.1.2 Calibrating the Z-offset ].
[ ►11.1.1 Using
2 1
3 4
to navigate the extruder to each calibration point.