Renkforce Pro 10+ Bedienungsanleitung Seite 61

14 Setting up Cura
14.1 Installing Cura on Windows
1. Download the Cura installation file from
cura.
2. Double-click the downloaded installation file and follow the on-screen installation
steps.
14.2 Installing the Windows
®
The printer requires a driver to interface with the Cura software.
Verify driver availability
1
The required driver may already be installed. Verify driver availability in the device man-
ager to determine if you need to install the driver.
1. Open the Device Manager.
2. Expand the section Ports (COM & LPT) and check for PL2303[name]. If
the driver is not installed, install it.
Installing the driver
2
1. Connect the supplied USB memory stick to your computer.
2. Then double-click the file "PL2303_Prolific_GPS_1013_20090319.exe" on this
driver.
®
https://ultimaker.com/software/ultimaker-
driver
14.3 Installing Cura on MacOS
1. Download the Cura DMG file from
2. Double-click the downloaded installation file and follow the on-screen installation
steps.
14.4 Configuring Cura for the Pro 10+
After installing Cura, follow the steps in the wizard to set up Cura for the Pro 10+.
1. Start the Cura software.
2. Follow the on-screen steps of the wizard. Under the step Add Printer, select
Renkforce > Renkforce Pro 10+. See screenshot.
3. Complete the setup by following the remaining steps of the wizard.
The Cura software is configured for the Pro 10+.
Æ
https://ultimaker.com/software/ultimaker-cura
61