Werbung
Verfügbare Sprachen
Verfügbare Sprachen
18 Troubleshooting
Problem
No power supply.
Display does not switch on.
Filament snaps.
Too little filament is extruded.
Nozzle touches print bed.
Printed object has defects.
Possible solution
Check mains connection.
Check fuse. Replace fuse if blown.
Check that filament spool turns freely.
Check if filament is trapped on the way from spool to extruder.
Clean the inside of the nozzle.
Clean the extruder.
Calibrate the print bed.
Check that set temperature matches temperature requirements of the filament in use.
Remove residual filament from nozzle.
65
Werbung
