Printing; Printing Via Mobile App; Printing Via Computer - Renkforce Cube One Bedienungsanleitung

10 Printing

There are two ways you can print 3D models: (1) use the mobile app and select models from the model library, (2)
connect the printer to a computer and use the open source software Ultimaker Cura. Printing via computer allows
you to print your own 3D models.

10.1 Printing via mobile app

To print from the mobile app, you select 3D models from the model library included in the mobile app.
Preconditions:
Print bed is levelled.
D
Printer is linked to mobile app.
D
1. In the mobile app, open the tab Model to access the model library.
2. Tap on a model to view information about the model. You must look for a model that matches the filament type you
are using with the printer. The supplied filament is of type PLA.
3. Touch Select model to select the model for printing.
4. Under the tab Printer, touch Print to start printing.
The model is sent to the printer.
Æ
The printer starts pre-heating.
Æ
The printer starts printing after pre-heating is completed.
Æ
5. Wait for the printing to complete.
6. (To pause printing) touch Pause to pause printing followed by Resume to resume printing.
7. (To cancel printing) touch Stop to cancel printing.

10.2 Printing via computer

To print via a computer, you must use the software Ultimaker Cura. Printing via computer allows you to print your
own 3D models.
Notes:
– Familiarize yourself with the software before printing. Look for online tutorials.
– It is assumed that you have your own model available in .stl format.
Preconditions:
Print bed is levelled.
D
1. Download the Ultimaker Cura software (V5 or higher) from
stall it on your computer.
2. Connect a suitable USB data cable to the port USB on the printer and a USB port on the computer.
3. Open the software.
4. Select the printer interface goofoo CUBE.
5. Load the 3D model .stl file into the software.
6. Start the printing.
The printer starts pre-heating.
Æ
The printer starts printing after pre-heating is completed.
Æ
7. Wait for the printing to complete.
www.ultimaker.com/software/ultimaker-cura and in-
33