Dalbach HE02 Gebrauchs- Und Montageanweisung Seite 55

15.1 Removing the oven door
The oven door can be removed for cleaning and for better access to the oven interior.
Open the oven door and press the folding brackets on the
•
hinges on both sides upwards.
Press the door slightly, lift it up and pull it out to the front.
•
Insert the oven door in the reverse order.
•
folding brackets upwards
• When inserting, make sure that the recess of the hinge fits
correctly with the hook of the hinge bracket.
Afterwards the two folding brackets must be put down again.
•
Otherwise, hinges can be damaged when closing the oven door.
Cleaning the inner glass plate
The inner glass plate in the oven door can be removed for cleaning.
Unscrew both plastic parts at the upper side corners of the oven
•
door and put them aside.
Remove the glass plate and clean it.
•
Insert the glass plate in the reverse order. Secure the glass
•
plate again with the two plastic parts.
15.2 Replacing the lamp
Lamp data for oven light (suitable for temperatures up to 300 °C):
Voltage: 230V
Power: 25W
Heat resistance: T300
Fitting: G9 (plug-in lamp)
Follow these steps to replace the oven light:
1. Switch off the fuse.
2. Let the oven cool down.
3. Open the oven door and remove the protective glass.
4. Turn defective lamp anti-clockwise and release.
5. Screw in the new lamp.
6. Fit the protective glass.
7. Switch on the fuse.
8. Turn the oven function selector to the "Light" level and check
whether the lamp works.
9. In event of a fault, please contact After Sales Service.
*Press the
Figure 14 Oven door 2
Figure 14 Glass plate
Abbildung16
lighting
EN
Figure 13 Oven door 1
Interior
Page | 55