Herunterladen Diese Seite drucken

BWT TC200 Einbau- Und Bedienungsanleitung Seite 13

Filtersystem zur optimierung von trinkwasser

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 3
f Chemicals, solvents and vapours must not come into contact with the filter system.
f The installation location must be protected against freezing and direct sunlight.
NOTE!*
f For installation and operation of the filter system, the BG regulation "Rules for Safety and
Health Protection When Working in Kitchens" of the "Food and Beverages" expert commit-
tee of BGZ (BGR111) must be observed. The filter system has been hygiene tested in accor-
dance with Section 7.4 DIN 18879-1.
f The materials are selected in accordance with the requirements of DIN 18879-1 and EN 14898.
f The pressure resistance of the filter system conforms to DIN 18879-1.
f The filtered drinking water conforms to liquid category 2 in accordance with EN 1717.
f Clean and descale the appliance, e.g. coffee machine, before firstly installing the filter
system.
f For immunocompromised people and infants it is recommended to boil the tap water before
drinking. This also applies to filtered water.
f For the protection against microbiological growth the filter cartridge contains a small
amount of silver ("bacteriostatic")*. There might be a harmless release of silver in concen-
trations below the recommendations of the World Health Organization (WHO). The term
" bacteriostatic" indicates that the system limits the passage or growth of bacteria already
existing in the incoming water*. It does not mean that the water leaving the system is safer
to drink than the water entering it.
4.1 Responsibility of the operator
  The installation and operating instructions must be kept in the immediate vicinity of the filter
 
system and must be accessible at any time.
  The filter system may only be operated in a technically perfect state ensuring a safe operation.
 
  The instructions in this installation and operating manual must be followed entirely.
 
4.2 Warranty and exclusion of liability
BWT warrants to the original purchaser/consumer all equipment that it munufactures to be free
from defects in material and workmanship for a period of 2 years from the date of purchase. This
warranty is subject to exclusions and limitations
The notes and recommendations listed, as well as local drinking water and recycling regulations,
must be met. All information and notes in this installation and operating manual account for
the applicable standards and regulations, state-of-the-art technology as well as our expertise
in water treatment. BWT does not assume any liability for damages or subsequent/secondary
damages arising from:
  Failure to comply with the instructions in this installation and operating manual
 
  Improper use
 
  Improper or faulty installation
 
  Improper commissioning, operation, maintenance
 
  Mechanical damage of the filter system
 
  Unauthorized modifications
 
  Technical modifications
 
  Use of non-certified, non-approved components
 
4.3 Qualified personnel
Only authorised, trained persons and professionals shall install, commission and maintain the filter
system.
  Authorised, trained persons have obtained instructions regarding the assigned tasks and
 
possible risks in case of misuse or improper operation.
  Professionals are in a position to install, commission and maintain the device, as a result
 
of their technical training, knowledge and experience, as well as knowledge of applicable
regulations.
EN
12

Werbung

loading