Inhaltsverzeichnis
Werbung
en
Switching off
the appliance
Press the On/Off button Fig. 1/2.
Refrigerating unit and interior light switch
off.
Disconnecting
the appliance
If the appliance is not used for
a prolonged period:
1. Pull out the mains plug
2. Cleaning the appliance
3. Leave the appliance door open.
Cleaning the appliance
1. Pull out the mains plug or switch off
the fuse.
2. Wipe the door seal with clear water
only and then wipe dry thoroughly.
3. Clean the appliance with lukewarm
water and a little washing up liquid.
Water for rinsing sold not reach
the lighting. Fig. r/A and B
Note:
Regularly clean the condensation
channel and drainage hole, Fig. e,
so that the condensation can flow out.
Clean the condensation channel with
cotton buds, etc.
The rinsing water must not run through
the drain hole into the evaporation pan.
36
After cleaning the appliance, re insert
the stopper into the drainage hole for
functional reasons.
Do not use abrasive or acidic cleaning
agents and solvents.
4. After cleaning: reconnect and switch
on the appliance.
Attention!
Never clean the shelves or containers
in the dishwasher. The parts may warp!
Cleaning the cool fresh
space
When cleaning the appliance, all drawers
and telescopic rails can be taken out of
the cool fresh" compartment.
Removing the drawers
Pull out the drawers all the way, lift up and
remove. Fig. q
When inserting the drawers, place them
on the telescopic rails and slide in
(drawers lock onto the telescopic rails).
Removing the humidity filter
The humidity filter, Fig. 1/9, above the
humidity drawer can also be removed.
To do this, first remove the humidity
drawer. Then, lift humidity filter and pull
out.
Lift filter cover, Fig. w, remove filter, clean
in luke warm water, allow to dry and
reassemble.
General information for
looking after the surfaces
Clean surfaces with luke warm water
and a little washing up liquid.
After cleaning, rub thoroughly dry.
Werbung
Inhaltsverzeichnis
