Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Screw on the cable using a cable lug and gear disc to one of the vehicle's ground
bolts.
Screw the cable to the sheet metal body work using a cable lug and a self-tapping
screw.
Ensure that there is a good ground connection.
•
When disconnecting the battery, all data stored in all volatile memory will be lost. Data may
be reset, depending on the vehicle equipment options. Follow the instructions of the re-
spective vehicle manufacturer in this case.
WARNING! Health hazard
Failure to obey these warnings could result in death or serious injury.
•
This monitor can be used by children aged from 8 years and above and persons with re-
duced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the monitor in a safe way and
understand the hazards involved.
•
Children shall not play with the monitor.
•
Cleaning and user maintenance shall not be made by children without supervision.
WARNING! Risk of injury
Failure to obey these warnings could result in death or serious injury.
•
Secure the monitor in such a way that it cannot become loose under any circumstances
(sudden braking, accidents) and cause injuries to the occupants of the vehicle.
•
Do not install the monitor anywhere in the vehicle where an airbag may open.
•
Inadequate supply line connections can result in short circuits, causing:
Cable fires
The airbag being triggered
Damage to electronic control devices
Electrical malfunctions (turn signal, stop light, horn, ignition, lights)
CAUTION! Risk of injury
Failure to obey these cautions could result in minor or moderate injury.
Lay the cables so that they cannot be tripped over or damaged.
NOTICE! Damage hazard
•
Do not expose the monitor and the monitor cable to excessive heat or cold, water, mois-
ture, dust, or smoke.
•
Do not use the monitor in direct sunlight, environments that are dusty or oily, have signifi-
cant temperature fluctuations, high humidity, or poor ventilation.
•
Avoid strong vibrations, e.g., by dropping the monitor.
•
Do not reverse connection cable polarity.
•
Fasten the cables securely.
•
Do not pull on the cables.
•
Ensure that there is sufficient space on the other side for the drill head to emerge.
•
When working on the electrical system, the batteries must be separated from the vehicle
ground. This applies to the main and additional batteries.
5
Werbung
