Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.3 PAIRING WITH THE CONTROLLER
3
Set the battery pack in the tool and while holding down the LED
light ON/OFF button, pull the Trigger switch.
The tool enters the pairing mode.
When the tool enters pairing mode, Display on Control Panel indicates the pairing
mode.
Wireless communication is automatically established and pairing registration is
completed.
When pairing registration is completed, Communication lamp No. 4 on the controller
stays lit.
• If pairing fails, cancel pairing on the controller and then try again.
Note
• You can enable pairing by setting in the setting screen in addition to using the key on the unit.
• For how to enable pairing in the setting screen and details on operation of the controller, see the
Operating Instructions supplied with the controller.
EN
Trigger switch
LED light ON/OFF
button
Display
Pairing mode
(rapid blinking)
- 91 -
Registered
(on)
Werbung
