Panasonic EYFMH1WC Bedienungsanleitung Seite 23

2.1 BASIC OPERATION
2.1.5 CONTROL PANEL FUNCTIONS
Power is in an OFF state when all the lamps on the control panel have gone out.
Pull the trigger switch once to activate the tool before operating it.
In the following cases, power will be in an OFF state to cut battery drain, and the LED
light and all the displays will go out.
• Just after a battery pack is attached
• When you have operated nothing for the following time
In [Stand Alone Mode]: About 5 minutes
In [Wireless Communication Mode]: About 120 minutes
When Tool Manager software is connected: About 20 minutes
Utilizing the LED Light
The LED light can be changed by the light
ON/OFF button among Linked to trigger,
Always lit, and Always out.
When you press the button once, the
present status will be shown on the display
of the control panel.
Then, whenever you press the button, LED
light settings will change.
Note
• While the light is lit, if you have operated
nothing for about 5 minutes, the light will
go out automatically.
• The light uses just a small current to light
up. It has little influence on the tool's
work capacity.
Display
d1
d2
d3
EN
LED light settings
Linked to trigger
Always lit
Always out
Display
- 23 -