Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.1 BASIC OPERATION
2.1.1 OPERATION MODE OF THE TOOL
The tool operates in one of the following modes.
The mode in which it is used now is shown on the display of the control panel.
Display
EN
Display
Mode name
Mode details
This is a mode in which the tool operates according to the
Stand Alone
configured parameters registered in its inside.
Mode
The history log data is recorded in the tool's internal storage.
The tool does not communicate with the controller.
The Tool Manager software is used to change the setting to
[Stand Alone Mode].
Refer to 2.2.8
This is a mode in which the tool is controlled via wireless
Wireless
communication.
Communication
The tool communicates with the controller to send the history log
Mode
data and receive the configured parameters.
Refer to 2.2.9
The tool has been locked by an operation prohibition signal from
Operation
the controller in the wireless communication mode.
Disable Mode
It will be unlocked by a release signal from the controller.
This is a mode to check the pairing status.
Pairing mode
It can also be done on the controller.
Refer to 3.3
This is a mode in which to check whether torque control is
Minimum
available when the target torque is low. The tool is shut off at the
Output Mode
minimum number of pulses.
The Tool Manager software is used to change the setting to
[Minimum Output Mode]. It can also be done on the controller.
Refer to 2.2.8
This is a mode in which to correct the calculated torque of the
Offset Mode
tool for the actual torque.
The Tool Manager software is used to change the setting to
[Offset Mode]. It can also be done on the controller.
Refer to 2.2.8
This is a mode in which the tool is in the factory default status.
Factory Default
Select [Stand Alone Mode] or [Wireless Communication Mode]
Mode
in accordance with your purpose using the Tool Manager
software before use.
- 17 -
Werbung
