Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.2 USING THE TOOL MANAGER SOFTWARE
2.2.8 CONFIGURING PARAMETERS OF THE TOOL
When you select [Adjust Torque Offset] and then, from the dialog displayed after that, save
and delete the history log data inside the tool, the offset setting window will open.
Perform the following procedure to set offsets.
1
Select a [Socket Extension Length] (①) to use from the pull-
down menu.
(If the length that matches the socket to use is not found, select the nearest length.)
2
Enter a numerical value that represents [Shut-off Torque] (②).
3
Select [Continue Offset] (③) to register the settings to the tool.
①
●
EN
②
●
③
●
- 45 -
Continued to the next page
Werbung
