Panasonic EYFMH1WC Bedienungsanleitung Seite 79

2.2 USING THE TOOL MANAGER SOFTWARE
2.2.13 HISTORY LOG ITEM LIST
Torque Result
[Display overview]
This shows the result value of torque that the tool output at the work concerned.
Upper Angle Limit (Before Snug)
[Display overview]
This shows the configured parameter of the upper limit of angle before snug for judging
the work result OK.
The angle before snug is an anvil turning angle from trigger-on to the snug point set by
the snug point parameter.
Lower Angle Limit (Before Snug)
[Display overview]
This shows the configured parameter of the lower limit of angle before snug for judging
the work result OK.
The angle before snug is an anvil turning angle from trigger-on to the snug point set by
the snug point parameter.
Angle (Before Snug)
[Display overview]
This shows the result value of the angle before snug of the work concerned.
The angle before snug is an anvil turning angle from trigger-on to the snug point set by
the snug point parameter.
Upper Angle Limit (After Snug)
[Display overview]
This shows the configured parameter of the upper limit of angle after snug for judging
the work result OK.
The angle after snug is an anvil turning angle from the snug point set by the snug point
parameter to the end of work.
Lower Angle Limit (After Snug)
[Display overview]
This shows the configured parameter of the lower limit of angle after snug for judging
the work result OK.
The angle after snug is an anvil turning angle from the snug point set by the snug point
parameter to the end of work.
- 79 -
EN