Selecting An Effect Program; Bypassing The Effect - Yamaha R100 Bedienungsanleitung

| SELECTING AN EFFECT PROGRAM |
Press the MEMORY button to engage the memory
eselection mode if the memory selection mode 15
NOT already active. The memory selection mode is NOT
active, for example, if the P1, P2, P3 or P4 LED indica-
tors is lit.
Note: If the PGM or MEMORY LED indicator is lit, it
. . will be necessary to hold the MIDI button down
continuously for about one second to return to the
PARAMETER or MEMORY mode.
2. Press the А and Y buttons to increment or decrement
the memory location number shown on the LED display.
Hold either of these buttons down for continuous incre-
menting or decrementing. Note that at this stage the LED
memory number display is flashing, indicating that al-
though a new location has been selected, its contents
have not yet been recalled.
3. When the desired memory location/effect has been se-
lected, press the RECALL button. The LED memory |
· number display will stop flashing and the selected effect.
will be engaged.
BYPASSING THE EFFECT
here are two ways to switch the selected effect in
and out: 1) with the control panel BYPASS button
and 2) with a footswitch connected to the rear-panel
FOOT SW BYPASS footswitch jack. An optional
Yamaha FC5 Footswitch can be used for foot-bypass
control. In either case — when the control-panel BY-
PASS key or BYPASS footswitch is pressed — the
BYPASS LED indicator will light. While BYPASS LED
is lit the R100 effect is bypassed and the input signal is
directly routed to the output terminals (i.e. the effect is
OFF).. Press the BYPASS button or footswitch a second
time to turn the effect back ОМ. ·